Category: Special lubricants for constant-velocity joints

    ISO L-XCCHB 2
    DIN 51502 : KPF 2K-30
    Z.St.9.55580 class II/ Grease II-approved for first filling.

Lubricating grease is primarily intended for the lubrication of constant velocity joints of trucks and passenger vehicles. It can be applied for the lubrication of loaded cylindrical and sliding bearings, slideways, joints, spindles, jaw couplings and other lubricating assembly blocks that are working in conditions of high loads.

Temperature interval of application: -30°C to +130°C.

Base Li-soap, mineral oil, solid lubricating additives
Consistency NLGI 2
Dropping point (°C) min 190
Weld load N min 4000
Packing 0.4kg 0.8kg 4kg 20kg 180kg eurocartridge 0,4kg

Category: Special lubricants for constant-velocity joints

    ISO L-XCCHB 2
    DIN 51 502:KPF 2K-35
    TL VW 738
    LÖBRO 4.9.06.00347

Lubricating grease intended for long-term lubrication of constant velocity joints of motor vehicles, construction and agricultural machinery. It can also be applied for the lubrication of cardan joints of jaw couplings, ball joints of handle bars on motor vehicles steering mechanisms and other extremely loaded sliding joints. It is tested at the manufacturers of constant velocity joints LÖBRO and TL VW and is recommended for 20 000 000 cycles.

Temperature interval of application: -35°C do +130°C.

Base Li-soap, mineral oil, solid lubricating additives
Consistency NLGI 2
Dropping point (°C) min 185
Weld load N min 3150
Packing 0.8kg 20kg