Category: Products for machining - active non-emulsifying

    ISO-L-MHF
    SRPS B.H3.526
    FAM IS 03 051

Active, mineral base, cutting oil. It is used for cooling and lubrication in processing carbon and low alloy steels by cutting, characterized by low resistances. It is not recommended for processing of light metals, non-ferrous metals and their alloys.

Viscosity at 40 ºC (mm²/s) 17
Density at 20 ºC (g/mL) 0.880
Flash point (ºC) min 180
Packing 20kg 180kg

Category: Products for machining - active non-emulsifying

    ISO-L-MHF
    SRPS B.H3.526
    FAM IS 03 051

Active, mineral base, cutting oil. It is used for cooling and lubrication in processing of steel and grey iron by cutting, which is characterized by medium-difficulty processing conditions

Viscosity at 40 ºC (mm²/s) 30
Density at 20 ºC (g/mL) 0.890
Flash point (ºC) min 180
Packing 180kg

Category: Products for machining - active non-emulsifying

    ISO-L-MHF
    SRPS B.H3.526
    FAM IS 03 051

Active, mineral base, cutting oil. It is used for cooling and lubrication in processing of high alloy steels by cutting, characterized by high speeds. It is not recommended for the processing of light metals, non-ferrous metals and their alloys.

Viscosity at 40 ºC (mm²/s) 19
Density at 20 ºC (g/mL) 0.900
Flash point (ºC) min 185
Packing 180kg

Category: Products for machining - active non-emulsifying

    ISO-L-MHF
    SRPS B.H3.526
    FAM IS 03 051

Active, mineral base, cutting oil. It is used for cooling and lubrication in processing of steel and grey iron by cutting, characterized by medium difficult processing conditions. It shows particularly good results in operations of gear hobbing, planing, profile grinding, thread rolling. It is not used for the processing of light and non-ferrous metals and their alloys.

Viscosity at 40 ºC (mm²/s) 19
Density at 20 ºC (g/mL) 0.890
Flash point (ºC) min 180
Packing 20kg 180kg

Category: Products for machining - active non-emulsifying

    SO-L-MHF
    SRPS B.H3.526
    FAM IS 03 306

Active, mineral base, cutting oil. It is used for cooling and lubrication in processing of high alloy and stainless steels, high temperature resistant steels, grey iron by the operation of external and internal vertical profile broaching in normal and high drawing speeds. It can be used also for the operations of deep drilling, threading and tapping

Viscosity at 40 ºC (mm²/s) 15
Density at 20 ºC (g/mL) 0.980
Flash point (ºC) min 145
Packing 180kg

Category: Products for machining - active non-emulsifying

    1ISO-L-MHF
    SRPS B.H3.526
    FAM IS 03 304

Active, mineral base, cutting oil. It is used for cooling and lubrication in processing of steel and grey iron by all the procedures of deep drilling in medium load conditions.

Viscosity at 40 ºC (mm²/s) 12
Density at 20 ºC (g/mL) 0.920
Flash point (ºC) min 160
Packing 180kg